Table of Contents
Advertisement
SETTINGS
The channel position set-up sub-menu »2:
?
? A
003
11. 494 GHZ
$
H – A
7.02 MHz 7.20 MHz
~
PANDA BW 1
–
( (
{
1
– – –
/ /
+
=
/
OK
____________________________________________________________________________
The receiver is already pre-programmed for the current channels of many satellites. In most cases,
no correction will be required.
However, new channels are continuously being added, or transmission frequencies being changed.
The current status of the transmission frequencies can be called up via the Teletext pages of various
channels (e.g. SAT 1 or 3SAT), via Internet, or can be found in a current satellite TV magazine.
You may then programme these channel positions in the "Channel position set-up" sub-menu and
you will have access to the image and sound settings of the individual channel positions.
1
Switch the satellite receiver on. Press the » « button followed by the
channel position set-up sub-menu »
Key to symbols:
?
?
A/B 001
11. 494 GHZ
$
H – A
7.02 MHz 7.20 MHz
~
PANDA BW 1
/
–
(
{
/
1
2
– – –
/
+ /
–
=
OK
«
?
?
/ /
«.
2:
Reception unit
A
or
B
(INPUT
receiver/ channel position number
Transmission frequency of the selected satellite channel
LNC settings:
Polarization H (horizontal) V (vertical)
– 22 kHz switching signal off
~
22 kHz switching signal on
Satellite selection A/B
Left/right sound carrier
PANDA, 50US (50µs), J17
(Deemphasis/noise reduction)
Bandwidth setting (BW 1, 2, 3 or 4)
Favourite programme marks
Contrast level 1 or 2
Decoder settings
Video polarity (positive/negative)
Exit menu without saving
Save and exit menu
»2
« button to display the
A
or B) of the satellite
–
off,
on
31
Advertisement
Table of Contents
