Assembly Of Cross Stand & Column Unit - Canvac Q Air CGF1403V Use Instructions

16
GB
ASSEMBLY OF CROSS STAND &
COLUMN UNIT
1. Undo the four sets of screws, washers and spring washers that are fitted
to the centre of the stand, then attach the extension pole to the stand using
these screws. (Fig. 1)
2. Loosen the height adjustment ring, lift the internal pole to the max height
and prevent the internal pole from slipping into the extension pole, then
unscrew and remove the height adjustment ring. (Fig. 2)
3. To attach the stand cover, slide the stand cover down the extension pole.
(Fig. 3)
4. Reattach the height adjustment ring. (Fig. 4)
5. Loosen the height adjustment ring on the extension pole and adjust the
internal pole to the desired height. (Note: If you cannot see the internal pole
it may have slipped inside the extension pole. You can pull it out from the
extension pole.) (Fig. 5)
6. To attach the head unit to the internal pole, loosen the thumb screw on the
bottom of the head unit. Place the head unit on the internal pole and tighten
the thumb screw until it is in line with the groove on the internal pole. (Fig. 6)
Fasten
Height
Stand cover
adjustment
ring
Four
screws
Stand
Tighten
Loosen
Annular groove
Thumb screw
Loosen
Mounting hole
© 2021, Elon Group AB. All rights reserved.