Table of Contents
Advertisement
1.
To simplify operation, the crimp head may be rotated by hand 360
2.
Depress ram retract button 2-3 times to ensure that ram is fully retracted.
3.
Carefully place terminal centrally between dies as shown above. Activate trigger until terminal is
held by dies.
CAUTION: Do Not crimp terminal.
4.
Check to ensure conductor (wire) size and dies properly match the terminal size being used.
Insert the stripped conductor into the terminal.
5.
Depress the trigger until the crimp is completed. The relief valve will sound when the crimp is
completed, and the crimp dies will automatically open as the ram returns to its initial position.
6.
Remove the crimped terminal/conductor wire and repeat the operation for a new terminal.
CAUTION:
NOTE:
•
By sliding the ram retract button in the direction of the battery, the dies can be retracted in
case of an error or emergency.
•
The terminal can first be pre-clamped. This allows the operator to adjust the position of the
terminal during the crimping cycle.
contacts the terminal and then release the trigger. The terminal can now be re-positioned or
even the wire can still be inserted into the terminal.
•
The crimping cycle is terminated when the dies are completely closed and the maximum
crimping force is reached, which is indicated by the auto retraction of the ram.
MAINTENANCE / INSPECTION
Daily Maintenance
Before Use:
1.
Inspect dies for wear or damage such as cracks, gouges, or chips.
2.
Inspect the tool for damage or leaks. If damage is detected, contact PANDUIT Tool
Division.
After Use:
1.
Wipe all tool surfaces clean with a damp cloth and mild detergent.
2.
Place the tool in the carrying case. Store in a cool, dry place.
3.
Charge the battery.
Monthly Maintenance
1.
Thoroughly clean all surfaces.
2.
Oil the locating pins.
Annually or After 10,000 Crimps
Return tool to PANDUIT Tool Division
CT-2600 & CT-2600/E
CT-2600 and CT-2600/E
Do Not press trigger and release button simultaneously. Damage to trigger
linkage may result.
PA26001A01_02
To use this feature, push the trigger until the die
Page: 8 of 11
o
relative to the tool body.
5-2009
Advertisement
Table of Contents
