Table of Contents
Advertisement
TOOL OPERATION
LED Display
This tool is equipped with a special circuit board incorporating several important features to inform the
user about the current status of the unit. The LED signals in the following cases:
SIGNAL
Preparing Wire and Positioning Terminals
Follow the instructions for appropriate wire strip length and crimp die as marked on the terminal
packaging. Position terminal centrally under crimp die as shown in Figures 2-4 on Page 7.
NON-INSULATED TERMINALS (P Series)
P8 & P6
Fig. 2
Crimping Terminals
ATTENTION: The crimping process can be interrupted at any time by releasing the
CT-2600 & CT-2600/E
CT-2600 and CT-2600/E
DURATION
A few seconds of
flashing
Glowing for 20
seconds
Flashing for 20
seconds (2Hz)
20 sec. glowing and
flashing intermittently
trigger. After having terminated the crimping process, remove
battery to avoid unintended starts.
PA26001A01_02
WHEN IT OCCURS
Battery insertion
After crimp
After crimp
After crimp
P4 & P2
Fig. 3
Page: 7 of 11
WHAT IT MEANS
Self check – O.K.
Battery discharged
Time for inspection and
preventive maintenance
Battery discharged –
Time for inspection and
preventive maintenance
PRE-INSULATED TERMINALS
(PV and PK Series)
PV8 – PV2
Fig. 4
5-2009
Advertisement
Table of Contents
