Table of Contents
Advertisement
Quick Links
REMOTE CRIMP HEAD HYDRAULIC COMPRESSION TOOL
© Panduit Corp. 2018
TABLE OF CONTENTS
SYSTEM SPECIFICATIONS ..................................................................................................................... 1
OPTIONAL ACCESSORIES (sold separately) .......................................................................................... 1
PRECAUTIONS AND GENERAL GUIDELINES ........................................................................................ 2
DIE SELECTION ....................................................................................................................................... 4
DIE INSTALLATION .................................................................................................................................. 4
TOOL OPERATION .................................................................................................................................. 5
MAINTENANCE ........................................................................................................................................ 6
PERIODIC MAINTENANCE ................................................................................................................ 6
CLEANING AND LUBRICATION OF TOOL HEAD .............................................................................. 6
VISUAL INSPECTION ......................................................................................................................... 6
FORCE INSPECTION / CALIBRATION ............................................................................................... 6
CONTACT INFORMATION ....................................................................................................................... 6
Email:
techsupport@panduit.com
EU Website:
www.panduit.com/emea
EU Email:
emeatoolservicecenter
@panduit.com
CT-2002CH
www.panduit.com
Technical Support
Tel: 1-800-777-3300
Panduit Europe • EMEA Service Center
Almelo, Netherlands
Tel: +31 546 580 452 • Fax: +31 546 580 441
PA29258A01
Rev. 00 6-2018
Advertisement
Table of Contents
Subscribe to Our Youtube Channel
Related Manuals for Panduit CT-2002CH
Summary of Contents for Panduit CT-2002CH
- Page 1 FORCE INSPECTION / CALIBRATION ....................6 CONTACT INFORMATION ........................6 Email: techsupport@panduit.com Technical Support Tel: 1-800-777-3300 EU Website: www.panduit.com/emea Panduit Europe • EMEA Service Center Almelo, Netherlands www.panduit.com EU Email: Tel: +31 546 580 452 • Fax: +31 546 580 441 emeatoolservicecenter @panduit.com...
- Page 2 305 L x 89 H x 56 W (mm) CT-2002CH Carrying Case: Included with CT-2002CH Tool NOTE: In the interest of higher quality and value, Panduit products are continually being improved and updated. Consequently, pictures may vary from the enclosed product.
- Page 3 OPERATION MANUAL CT-2002CH © Panduit Corp. 2018 PRECAUTIONS AND GENERAL GUIDELINES This symbol is used to call your attention to hazards or unsafe practices which could result in an injury or property damage. The signal word, defined below, indicates the severity of the hazard.
- Page 4 OPERATION MANUAL CT-2002CH © Panduit Corp. 2018 WARNING • An incomplete crimp can cause a fire. • Use proper compression connector and cable combinations. Improper combinations can result in an incomplete crimp. • The relief valve will sound to indicate a completed crimp. If you do not hear the sound of the relief valve, the crimp is not complete.
- Page 5 DIE IDENTIFICATION FOR USE WITH MATCHED COMPRESSION CONNECTOR NOTE: DIES ARE DESIGNED TO PRODUCE THE HIGHEST QUALITY CONNECTIONS WHEN USED WITH PANDUIT COMPRESSION CONNECTORS. USE OF ANY OTHER BRAND OF COMPRESSION CONNECTORS IS NOT RECOMMENDED WITH CD-2001 DIES. FIGURE 2...
- Page 6 CT-900HPH High Pressure Hose (electrically non-conductive; 10 foot long) are recommended. This system's fittings are matched to the tool head fittings The CT-2002CH Tool Head has been charged with hydraulic fluid at the factory. Remove the dust cap from the connector coupling on the tool.
- Page 7 The tool output force can be certified by using a Panduit Compression Gauge, PG-1 (purchased separately, see Optional Accessories on Page 1); or return tool to Panduit Global Service Center for maintenance and calibration.
Need help?
Do you have a question about the CT-2002CH and is the answer not in the manual?
Questions and answers