Table of Contents
Advertisement
CRIMP DIES AND ACCESSORIES
CD-2600 Series Compression Dies
CT-2600BC
CT-2500CHR
CT-2500CHR/E
Makita 7.2 Volt – 18.0 Volt
Makita 7.2 Volt – 18.0 Volt
Replacement Makita Batteries and Battery Chargers are available for purchase from local Makita
products distributors.
DIE SELECTION AND INSTALLATION
Refer to product packaging label to verify terminal to die combinations.
NOTE:
DIES ARE DESIGNED TO PROVIDE THE HIGHEST QUALITY CRIMPING WHEN USED WITH
PANDUIT TERMINALS. CONNECTIONS UTILIZING THIS TOOL ARE LISTED PER U.L. 486A AND
C.S.A. CERTIFIED ONLY WHEN PANDUIT TERMINALS ARE USED. USE OF ANY OTHER BRAND
OF TERMINALS IS NOT RECOMMENDED WITH CD-2600 DIES.
NOTE: Remove battery from tool before removing or installing dies in the crimp head.
1.
Remove any current dies from the tool ram by opening locking flange in crimp head and pulling die
out of tool.
CAUTION: Do Not let the ram contact the crimp head.
2.
Select the appropriate dies to match the terminal to be crimped.
1.
Slide one of the die halves into the crimp head until it snaps into place.
2.
Properly position the remaining die half into the crimp head until it snaps into place, and close the
locking flange.
3.
Replace the battery and slowly activate the tool to ensure that the die halves are properly aligned
without binding or interference in the crimp head.
NOTE: DO NOT operate tool if dies are not properly aligned and snapped (locked) in place.
CT-2600 & CT-2600/E
CT-2600 and CT-2600/E
(sold separately)
Consult PANDUIT catalog or website for part numbers and
specific die application information.
Replacement Battery Cartridge
Replacement Battery Charger
Replacement Battery Charger for Europe
replacement battery charger
DC
replacement battery charger for EU
DC
PA26001A01_02
Makita Part No.: DC1804
Makita Part No.: DC1804F
Page: 6 of 11
5-2009
Advertisement
Table of Contents
