Steering Wheel Controls - Scosche FD5000SW Manual

STEERING WHEEL CONTROLS

1. Determine if your vehicle has built-in stereo (audio)
control buttons located on the steering wheel:
a. If yes, proceed to step 2.
b. If no, then disregard this steering
wheel controls section.
2. Determine if your new stereo is compatible with
steering wheel controls. Consult the installation
manual provided with the stereo, or check the
wiring connections behind the stereo:
a. Some stereos have a 3.5 mm round (headphone type)
input receptacle at the rear of stereo
labeled "SWC" or "SWC In"
b. Some stereos have Blue wire with Yellow stripe
(or other color) labeled: "SWC" or "SWC In".
3. Refer to chart on page 9 to prepare the Steering Wheel Control harness. Use the chart to determine
which colored loop to cut and the corresponding connection for your particular stereo. If your brand
is not listed in the chart, please call tech support for assistance: (800) 612-3695 Ext. 3
4. Connect the 3.5mm Male jack the back of the stereo's SWC input or connect the Brown (KEY1), Gray
(KEY2) or Black (GND) to the stereo's SWC input wire.
5. Connect the Male 14-Pin connector the interface module as shown in the diagram.
**NOTE: Steering wheel control buttons and functions are provided as a guide. Your specific vehicle may differ.
8