WIRING NOTES
1. The Red +12V switched accessory wire coming from the FD5000SW interface is rated at 10 amps for
use with a single Aftermarket stereo. Connecting additional accessories to this +12V power source can
cause damage to the FD5000SW module.
2. There are wires connected ONLY between the FD5000SW interface plug and the vehicle connectors
(under the insulating tape). Do not make any connections or cuts to these wires.
3. If your stereo does not contain an "Orange" illumination wire, then the orange wire will not be used.
Tape or cap all unused wires to prevent short circuits
WIRE COLOR CODES:
White
= Left front positive (LF+)
White/Black = Left front negative (LF-)
Green
= Left rear positive (LR+)
Green/Black = Left rear negative (LR-)
Gray
= Right front positive (RF+)
Gray/Black = Right front negative (RF-)
Violet
= Right rear positive (RR+)
The color codes used on this interface harness conform to the standards set by the E.I.A. (Electronics
Industry Association). They may differ from the wiring codes found on your car stereo. Always refer to
your stereo owners manual for wiring details about your particular car stereo.
Violet/Black = Right rear negative (RR-)
Violet/White = Reverse trigger (-)
Yellow
Red
Black
Orange
6
= +12 volt battery constant
= +12 volt accessory switched
(DATA-controlled / R.A.P.)
= Chassis ground (-12V)
= +12V illumination