Scosche FD5000SW Manual page 2

WHY YOU NEED THIS PART:
Your factory stereo is an integral part of your vehicle's data and communication systems. If the stereo is
removed without the proper installation accessory, some functions of your vehicle will be LOST including:
• +12V accessory power at stereo's location
• R.A.P. (Retained Accessory Power) feature
• Communicates proper command signals with host computer during vehicle
service or diagnostic operations (SEE NOTE)
• Steering wheel audio controls (if equipped)
NOTE: Your vehicle's ECM (Electronics Control Module) may store an error code if operated without
the factory stereo installed and you may experience difficulty when having the vehicle serviced at the
dealership. The FD5000SW Interface module / harness will allow you to REPLACE the factory stereo and
RETAIN the original power and communication signals.
BEFORE BEGINNING: READ THIS INSTRUCTION MANUAL
**CAUTION**:
manufacturers warnings regarding air bags and electrical systems in your vehicle. We
recommend the use of a volt-ohm meter or computer-safe LED probe when checking
wiring. A test light or grounded light probe if used improperly can cause damage to the
vehicle's computer and/or diagnostic system.
NOTE:
We recommend the FD3090A Car Stereo Installation Kit for mounting your
aftermarket car stereo and a TK12A car stereo tool kit.
Disconnect negative battery terminal to avoid short circuits. Read ALL
2