Display Event Log And Current Settings, Execute Maintenance (Maintenance) - Canon VB-C60 Operation Manual

Display Event Log and Current Settings, Execute Maintenance (Maintenance)

You can configure following settings.
● Tool
For displaying and initializing the camera's settings.
▼Tool
1 View Log Events
Display a log file, showing the camera's operation and connection with viewers (➞ P. 2-36).
2 View Current Settings
Display a list of current settings.
3 Reboot
Reboot the camera.
4 Restore Settings
All settings will be restored to the factory default settings, except camera's administrator
password, IP address, subnet mask, default gateway address, date and time, time zone, LAN
interface, maximum transmission unit, and IPv6 use. The camera will be automatically rebooted
after the restoring process.
Do not turn off the camera while it is restoring the settings, otherwise the camera
may not operate properly.
Note
● It is recommended that you make a note of the current settings before you restore
the factory default settings in "Restore the Factory Default Settings" (➞ P.5-14)
Tip
● The camera's Reset switch can also be used to restore the factory default settings,
but note that this will reset all settings (➞ P.5-15).
1-44
1 2
1 2
1
1 2
1 2 1 2
2
1 2
3
1 2
1 2
4