E13: Water Leaks - Electrolux EWM10931 Service Manual

E13
Maximum overall water fill time exceeded (sum of all water fills between one drain
Checks to perform:
Run the diagnostic cycle and fill all the trays with watern (phases 2,3,4,5,6)
N
O
Is the drain pipe positioned
correctly and not causing the
siphon effect? -(fig.1)-
Is the washing machine's water
circuit efficient (leaking)?
Is the pressure switch's water circuit
efficient (leaking/clogged)?
Is one or are all the solenoid valves
not working?
Is the resistance measurement of the solenoid
valve approximately 3.5÷4.5 kΩ? (Measure it
directly on the solenoid valve without wiring)
-(see fig.3)-
Reconnect the connector and measure
approximately 3.5÷4.5 KΩ on the solenoid
valve wiring connector on the circuit board side
-(fig.4)-: Between J7-1 and J7-3 wash
Between J7-4 and J7-6 pre-wash
Between J8-1 and J8-3 third solenoid valve
Between J8-4 and J8-6 hot water
Is the solenoid valve wiring ok?
Replace the main circuit board and repeat
the diagnostic cycle to check for any
further alarms.
2011 SOE/DT-mdm FCPD-dp Quality-tb
Guide to diagnostics of electronic controls EWM10931

E13: Water leaks

phase and the next to avoid exceeding the maximum volume)
Are all the trays filling with water?
Y
E
S
Y
E
S
Y
E
S
-(fig.2)-
Y
E
S
Replace the main circuit board and repeat the diagnostic cycle to check
Y
E
S
Y
E
S
Y
E
S
!
Check that all the connectors are correctly inserted
Repair the drain circuit and repeat
the diagnostic cycle to check for any
NO
Repair the water circuit and repeat
the diagnostic cycle to check for any
NO
Repair the water circuit of the pressure
switch and repeat the diagnostic cycle to
NO
check for any further alarms.
for any further alarms.
Check whether the tap is open, if the
water pressure is too low and make sure the
NO
tubes are connected and not kinked.
Replace the solenoid valve and repeat
the diagnostic cycle to check for any
NO
Replace/repair the wiring and repeat
the diagnostic cycle to check for any
NO
!
22/75
further alarms.
further alarms.
further alarms.
further alarms.
If there are burns on the circuit
board, see page 73
E13
599 73 77-37