E68: Washing Heating Element Leakage - Electrolux EWM10931 Service Manual

E68
Checks to perform:
Run the diagnostic cycle
and fill with water up to the
door level to make sure the
heating element is
completely submerged.
Measure between the wiring
connector J3-1/J3-2 and the
appliance body.
-(see fig.6)-
Is the circuit open?
Y
E
S
Replace the main circuit
board and repeat the
diagnostic cycle to check for
any further alarms.
Fig. 6
Fig. 19
If there are burns on the circuit
!
board, see page 73
2011 SOE/DT-mdm FCPD-dp Quality-tb
Guide to diagnostics of electronic controls EWM10931

E68: Washing heating element leakage

Detach the connectors
and measure between
the heating element
and the earth contact.
NO
-(see fig.19)-
Is the circuit open?
Check/replace the wiring and repeat the diagnostic cycle to
J16 J13 J15
Fig. 4
Washing heating element
∞ Ω
∞ Ω
!
Check that all the connectors are correctly inserted
NO
Y
E
S
check for any further alarms.
J10 J11 J4
J12
∞ Ω
55/75
Run phase 9 of the
diagnostic cycle, drain water
from the tub. Replace the
heating element and repeat
the diagnostic cycle to
check for any further alarms.
J8
J7 J6
J5
J9
J3
J1
MAIN CIRCUIT
BOARD
599 73 77-37
E68