Progress PHP5325X User Manual page 32

32 Progress
2
1
Install the shelf supports in the opposite
sequence.
Pyrolysis
CAUTION! Remove all
accessories and removable shelf
supports.
The pyrolytic cleaning
procedure cannot start:
• if you did not fully close the
oven door. In some models,
the display shows "C3" when
this error occurs.
CAUTION! If a hob is installed
above the appliance or if there
are other appliances installed in
the same cabinet, do not use
them at the same time as the
Pyrolysis function. It can cause
damage to the appliance.
During the pyrolytic cleaning the door is
locked. The symbol
heat indicator come up, until the door
unlocks. The door unlocks when the
temperature inside the oven is under safety
conditions and the pyrolytic cleaning
finishes.
During the pyrolytic cleaning the lamp is
deactivated.
1. Remove the worst dirt manually.
2. Clean the inner side of the door with hot
water, so that the residues do not burn
from the hot air.
3. Set the Pyrolysis function (refer to
"Oven functions").
and the bars of the
4. Touch
or
the cleaning procedure:
Option
1
2
3
You can use the End function to delay
the start of the cleaning procedure.
5. Touch to activate the Pyrolysis
function.
Cleaning reminder
To remind you that the pyrolytic cleaning is
necessary, the cleaning reminder symbol
flashes in the display after each
deactivation of the appliance for the next 10
seconds.
The cleaning reminder goes
out:
• after the end of the pyrolytic
cleaning.
• when you deactivate it in the
basic settings. Refer to
"Using the settings menu".
Removing and installing the
door
You can remove the door and the internal
glass panels to clean it. The number of
glass panels is different for different models.
WARNING! Be careful when
you remove the door from the
appliance. The door is heavy.
1. Open the door fully.
2. Fully press the clamping levers (A) on
the two door hinges.
to set the duration of
Description
1:00 h for a low
degree of dirt
1:30 h for a usual
degree of dirt
2:30 h for a high
degree of dirt