Input Source Selection (ANALOG PC: COMPUTER 1/COMPUTER 2)
Direct Operation
Choose either COMPUTER 1 (ANALOG PC) or COMPUTER 2 (ANALOG PC) by pressing the COMPUTER 1 or
COMPUTER button on the remote control unit.
Before using these buttons, correct input source should be selected through Menu operation as described below.
Remote control unit
Menu Operation
1
Press the MENU button to display the On-Screen
Menu. Use the Point ▲▼ buttons to select Input
and then press the Point ► or the OK button.
2
Use the Point ▲▼ buttons to select COMPUTER 1.
OR
Use the Point ▲▼ buttons to select COMPUTER 2
and then press the OK button.
3
When COMPUTER 1 is selected, press the Point
► button to access the submenu items. Use the
Point ▲▼ buttons to select the ANALOG PC
input source and then press the OK button.
Note:
When the Auto input function is set to On 1
or On 2 in the Auto setup function, the input
signal will be searched automatically (p.5).
30
Computer Input
COMPUTER 1 button
COMPUTER 1 (ANALOG PC)
COMPUTER 1(SCART)
COMPUTER 2 button
COMPUTER 2 (ANALOG PC)
Input Menu
COMPUTER 1