Attaching The Lens Cap; Cleaning The Projection Lens; Cleaning The Projector Cabinet - Canon LV-8225 User Manual

When moving this projector or while not using it over
an extended period of time, attach the lens cap.
Attach the lens cap according to the following
procedures.
1
Thread the string through the hole on the lens
cap and then tie a knot in the string to secure it
in place.
2
To pass the other end of the string into the hole
on the bottom of the projector and pull at it.
Unplug the AC power cord before cleaning.
Gently wipe the projection lens with a cleaning
cloth that contains a small amount of non-abrasive
camera lens cleaner, or use a lens cleaning paper or
commercially available air blower to clean the lens.
Avoid using an excessive amount of cleaner. Abrasive
cleaners, solvents, or other harsh chemicals might
scratch the surface of the lens.
Unplug the AC power cord before cleaning.
Gently wipe the projector body with a soft dry
cleaning cloth. When the cabinet is heavily soiled,
use a small amount of mild detergent and finish with
a soft dry cleaning cloth. Avoid using an excessive
amount of cleaner. Abrasive cleaners, solvents, or
other harsh chemicals might scratch the surface of
the cabinet.
When the projector is not in use, put the projector in
an appropriate carrying case to protect it from dust
and scratches.
CAUTION
Do not use any flammable solvents or air
sprays on the projector and in its vicinity.
The explosion or fire hazard may occur
even after the AC power cord is unplugged
because the temperature inside the projector
is extremely high due to the lamps. In
addition, there is a risk that the internal parts
may be damaged not only by the flammable
air spray but also by the cold air.
Attaching the Lens Cap
Cleaning the Projection Lens
Cleaning the Projector Cabinet
Maintenance and Cleaning
67