Canon LV-8225 User Manual page 59

Lamp mode
This function allows you to change brightness of the
screen.
High ............. Brighter than the Normal mode.
Normal ......... Normal brightness
Eco .............. Lower brightness reduces the lamp
power consumption and extends
the lamp life.
Note:

• Lamp mode can not be changed for a
while after turning on the projector. Lamp
needs some time to stabilize after the
power is turned on. Stored lamp mode will
be active after the lamp is stabilized.
Remote control
This projector provides two different remote control
codes: the factory-set initial code (Code 1) and the
secondary code (Code 2). This switching function
prevents remote control unit interference when
operating several projectors or video equipment at the
same time.
When operating the projector in Code 2, both
the projector and the remote control unit must be
switched to Code 2.
To change the code for the projector:
Select either Code 1 or Code 2 in this Setting Menu.
To change the code for the remote control unit:
Press and hold both the MENU and IMAGE buttons
together for 5 seconds or more. After changing the
code, make sure the remote control unit operates
properly.
Note:

• When different codes are set on the
projector and on the remote control unit,
any operation cannot be made. In that
case, switch the code on the remote
control unit to fit the code on the projector.
• If the batteries are removed from the
remote control unit for a long period of
time, the remote control code will be reset.
Remote control
Setting
59