Error Codes - ETC HIGH END SYSTEMS LONESTAR User Manual

Error Codes

When you apply power to the fixture, it runs a calibration (homing) sequence and displays any
errors that it detects.
Example:
an error in channel 1. When multiple errors are present they will cycle on the display
twice, and then the fixture will reset (restart). Any errors that remain after two reset
cycles are not correctable by reset alone and will require service. These errors are
stored in the fixture error history until the errors are cleared. Please contact Technical
Services for assistance.
Animation
This message displays after the reset of the fixture if any of the following conditions exist:
the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
l
the stepper motor is defective or the related IC driver on the main PCB has failed
l
the Animation wheel is not located in the default position after the reset
l
Animation_Rot
This message displays after the reset of the fixture if any of the following conditions exist:
the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
l
the stepper motor is defective or the related IC driver on the main PCB has failed
l
the Animation Rotating wheel is not located in the default position after the reset
l
Blade Rot
This message displays after the reset of the fixture if any of the following conditions exist:
the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
l
the stepper motor is defective or the related IC driver on the main PCB has failed
l
the Blade rotation is not located in the default position after the reset
l
Color
This message displays after the reset of the fixture if any of the following conditions exist:
the fixture head's magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
l
the stepper motor is defective or the related IC driver on the main PCB has failed
l
the Color wheel is not located in the default position after the reset
l
CMY
This message displays after the reset of the fixture if any of the following conditions exist:
the fixture head's magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
l
the stepper motor is defective or the related IC driver on the main PCB has failed
l
the CMY wheel is not located in the default position after the reset
l
26
When the display shows "Err channel: Pan Movement", it means there is
Lonestar User Manual