Replace A Gobo; Error Codes - ETC Halcyon Gold User Manual

Replace a Gobo

Halcyon Gold gobos are user-replaceable. The Halcyon Replacement Gobo Installation Guide is
available for free download from the ETC website: etcconnect.com/Halcyon/Documentation.

Error Codes

When you apply power to the fixture, it runs a calibration (homing) sequence and displays any
errors that it detects.
Example:
an error in channel 1. When multiple errors are present they will cycle on the display
twice, and then the fixture will reset (restart). Any errors that remain after two reset
cycles are not correctable by reset alone and will require service. These errors are
stored in the fixture error history until the errors are cleared. Please contact Technical
Services for assistance.
Animation
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Animation wheel is not located in the default position after the reset
Animation_Rot
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Animation Rotating wheel is not located in the default position after the reset
Blade Rot
This message displays after the reset of the fixture if any of the following conditions exist:
• the magnetic-indexing circuit malfunctions (optical or magnetic sensor failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Blade rotation is not located in the default position after the reset
Color
This message displays after the reset of the fixture if any of the following conditions exist:
• the fixture head's magnetic-indexing circuit malfunctions (optical or magnetic sensor
failure)
• the stepper motor is defective or the related IC driver on the main PCB has failed
• the Color wheel is not located in the default position after the reset
Replace a Gobo
When the display shows "Error channel: Pan Coarse", it means there is
26