Table of Contents
Advertisement
Operation
EMPTYING THE BAGS
Raise the bagger cover. If a plastic liner was not used,
unhook the bag and turn upside down to empty (use handle
on bottom).
If plastic liner was used, first tie top of liner closed. Then,
either pull the liner out, or turn the bag upside down and
allow the filled liner to slide out.
AFTER OPERATION
Remove any debris from the the screen on the underside
of the lid. Note: The lid screen can be partially removed for
easier cleaning and should be cleaned regularly.
The blower housing and tube should be removed for
cleaning. Inspect the grass bags for wear or damage. Make
sure that there is a snug fit between mower deck, blower
housing, tubes, and grass catcher cover.
12
STORAGE
The adapter and tube should be removed for cleaning.
Unhook the wire form and remove the tube from the
adapter. Loosen the wing nut securing the adapter to
mower deck.
Clean the tube with mild detergent (other products may
damage tube). Inspection windows can be removed to be
cleaned. Make sure windows are securely in place before
operating.
If paint has been scratched on metal parts, touch up with
paint, or apply a thin film of oil to prevent corrosion.
Store in a dry area. Dry thoroughly before storing for a long
period of time. Always store away from moisture.
REQUIRED ACCESSORIES
A front-mounted weight carrier and approved weights are
required when using this rear-mounted grass catcher.
Never operate on slopes greater than 17.6% (10°).
Advertisement
Table of Contents
