Table of Contents
Advertisement
Cabinet
Sheet metal thickness
Dimensions & weight
Overall dimensions, LxWxH
Shipping dimensions, LxWxH
Net weight, approx.
Shipping weight, approx.
1
Subject to local/national electrical codes. Recommendation based upon dedicated circuit.
2
The specified values are emission levels and are not necessarily to be seen as safe operating levels. As workplace
conditions vary, this information is intended to allow the user to make a better estimation of the hazards and risks
involved only.
L = length, W = width, H = height, T = thickness
n/a = not applicable
The specifications in this manual were current at time of publication, but because of our policy of continuous
improvement, JET reserves the right to change specifications at any time and without prior notice, without incurring
obligations.
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of
the following measures:
--Reorient or relocate the receiving antenna. --Increase the separation between the equipment and receiver. --Connect
the equipment into an outlet on a circuit different from that to which the receiver is connected. --Consult the dealer or
an experienced radio/TV technician for help.
CAUTION:
To assure continued FCC compliance:
Any changes or modifications not expressly approved by the grantee of this device could void the user's
authority to operate the equipment.
FCC ID：2AX7W-IAFSRC
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This
device may not cause harmful interference, and (2) this device must accept any interference received, including
interference that may cause undesired operation.
415100
IAFS-1700
36-11/16 x 24 x 20-9/32 in. (932 x 610 x 515
/mm)
43-23/32 x 27-5/32 x 29-15/16 in.
(1110 x 690 x 760 mm)
136 lb. (62 kg)
176 lb. (80 kg)
6
415125
IAFS-2400
16 ga.
41-13/16 x 27-3/4 x 23-3/8
in. (1062 x 705 x 594 mm)
45-9/32 x 30-21/32 x 32-
11/16 (1150x780x830mm)
150 lb. (68 kg)
197 lb. (89.5 kg)
187 lb. (85 kg)
415150
IAFS-3000
244 lb. (111 kg)
Advertisement
Table of Contents
