Canceling Sending - Canon imageCLASS D880 Fax Manual

■ Using the platen glass
• You need to remove documents in the ADF in advance, in order to fax from the platen glass.
• You can operate Book Sending, Delete or Clear when the Function key is lit. If the Function key
NOTE
is not lit, press Function. However, you do not need to press Function in Step 3 to execute the Book
Sending mode if BOOK SENDING is programmed in PROGRAM 1-TOUCH KEY from ADDTIONAL
FUNCTIONS. (→ p. 9-4)
Press FAX to set to the Fax Mode.
F A X 1 2 / 0 3 / 2 0 0 4 1 5 : 3 0
F a x T e l
Ex:
Prepare the document and place it face
down on the platen glass. (→ Basic Guide)
• To adjust the resolution, → p. 4-1.
• To adjust the contrast, → p. 9-4.
Press Function.
Press Book Sending.
Press 4 (–) or e (+) to select the
document size.
B O O K T X S C A N S I Z E
Ex:
Press Set.
Dial the other party's fax number.
T E L =
Ex:
• For dialing methods, → p. 4-2.
• If you enter the wrong number, press Delete to
delete the last number or press Clear to clear your
entire entry, then enter the correct number. You can
also delete all the numbers by pressing Stop/Reset.

Canceling Sending

Canceling memory sending
■ To cancel memory sending while documents are being scanned using the ADF
Press Stop/Reset.
• Scanning is canceled.
S T O P K E Y P R E S S E D
P R E S S S E T K E Y
4-6
S T A N D A R D
L T R
9 0 5 7 9 5 1 1 1 1
• If you must first dial a number to get an outside
line ("9", for example), add a pause after that
number by pressing Redial/Pause.
Press Start to begin scanning.
N E X T P A G E : [ S T A R T ]
F I N I S H S C A N : [ S E T ]
Place the next document on the platen glass
and press Start to begin scanning.
• Repeat for other documents.
After all of the documents have been
scanned, press Set to begin sending.
• To cancel sending after dialing has started, press
Stop/Reset then press 4 (–). (→ p. 4-7)
• You can scan up to approximately 255
pages* for memory sending.
NOTE
* Based on ITU-T No.1 Chart, Standard
mode.
• The Function key will light up by
pressing Function to be able to operate
Delete or Clear.
• If the machine's memory becomes full
while scanning your document, MEMORY
FULL will appear on the LCD display. If
this happens, divide the documents into
several sections and send each section
separately.
Press Set.
• The document will come out automatically.