Troubleshooting - Tesla 3 Series User Manual

ENG
Filter replacement force mode
When using the air purifier in an environment of heavy pollution, the lifespan of the air filter may be
significantly reduced. You can change the filters even if
perform a hard reset.
1. Replace the air filters as mentioned in the Filter Replacement section.
2. Plug in the air purifier and keep in standby mode.
3. Press and hold
4. Press and hold
STORAGE
Unplug the power cord, then wipe the machine clean, put the appliance in the packing bag ,then put it in a
dry place away.
ENVIRONMENT
Do not throw away the appliance with the normal household waste at the end of its life, but hand it in at an
official collection point for recycling. By doing this, you help to preserve the environment.

TROUBLESHOOTING

This chapter summarises the most common problems you could encounter with the appliance. If you are
unable to solve the problem with the information below, contact the Consumer Care Centre in your country.
Problem
Air purifier does not
power on.
Air purifier does not
respond to button
for 3 seconds, and it will light up.
again for 3 seconds, and it will turn off. The reset is now complete.
Cause
Unit is not plugged into an
electrical outlet.
Outlet is not working properly.
Power button has not been
pressed after plugging in the air
purifier.
Power cord is damaged.
Air purifier is defective or
malfunctioning.
Air purifier is not plugged into
an outlet.
Air purifier is defective or
malfunctioning.
does not light up. Follow the steps below to
Solution
Connect the plug to a powered electrical
outlet.
Try plugging the air purifier into a different
outlet.
Press once to turn on the air purifier.
Immediately discontinue use and contact
Customer Support
Connectthe plug to a powered electrical
outlet.
Immediately discontinue use and contact
Customer Support.
10