Programming Example; Reading And Setting The Clock; Preparatory Operations - Omron SYSMAC CPM2B Operation Manual

Programming Example

6-2-28 Reading and Setting the Clock

1, 2, 3...
6-3

Programming Example

6-3-1 Preparatory Operations

1, 2, 3...
106
This operation is used to read or set the CPU's clock. The clock can be read in
any mode, but can be set in MONITOR or PROGRAM mode only.
Operation
Read clock OK
Set clock No
1. Press the CLR Key to bring up the initial display.
2. Press the FUN Key, SHIFT Key, and then the MONTR Key to display the
date and time.
SHIFT MONTR
FUN
3. Press the CHG Key to change the date and/or time.
The digit that can be changed will flash. If necessary, input a new value with
the Up and Down Arrow Keys or Numeric Keys. Press the CHG Key to move
the cursor to the next digit. The following table shows the setting ranges for
each value.
Year Month
00 to 99 01 to 12
4. Press the WRITE Key to write the new value.
WRITE
Press the CLR Key to return to the initial display.
This section demonstrates all of the steps needed to write a program with the
Programming Console.
Use the following procedure when writing a program to the CPM2B for the first
time.
1. Set the Programming Console's mode switch to PROGRAM mode and turn
on the CPM2B's power supply. The password input display will appear on
the Programming Console.
MONITOR
RUN PROGRAM
2. Enter the password by pressing the CLR and then the MONTR Key.
CLR MONTR
RUN MONITOR
OK
OK
TIM 99 02 22
11:04:32
TIM CHG?99 02 22
CHG
11:04:32
Day Hour Minute
01 to 31 00 to 23 00 to 59
INST TBL
FUN018:HEX
<PROGRAM>
PASSWORD!
<PROGRAM>
Section 6-3
PROGRAM
OK
OK
MON(1)
MON(1)
Second Day-of-week
00 to 59 0 to 6
(SUN to SAT)
READ
BZ