A-20
Appendix A: Core Module upgrades using NTND33BB/BC/BD Cable Kits
Table A-7
Group 0 connections on the left I/O panel: NTND94CA cables
Core 0 cable label
CPU0-CNI-8F to
3PE-GRP0/0-J4
CPU0-CNI-8D to
3PE-GRP0/0-J3
553-3001-250 Standard 14.00 August 1996
5
For Group 0, attach adapters and cables from the NTND33BB kit to the
inside of the left I/O panel for each Core Module.
•
The inside of the I/O panel faces the backplane. The word LEFT
faces the outside of the module. The slot numbers listed below
match the designations on the outside of the panel.
•
Mount an A0360683 50-pin adapter at slot J32, pin 1 to the top.
•
Mount an A0369106 9-pin filter adapter at slot J29, pin 1 to the
bottom, using the A0314862 screw lock kit.
•
Mount an A0369106 9-pin filter adapter at slot J33, pin 1 to the
bottom, using the A0314862 screw lock kit.
•
Connect the NTND94CA CNI cables to the inside of the I/O panels
as listed in Table A-7.
Core 1 cable label
CPU1-CNI-8F to
3PE-GRP0/1-J4
CPU1-CNI-8D to
3PE-GRP0/1-J3
•
Plug an NT1R04AA cable into the adapter on slot J32 and lock the
cable in position:
–
In Core 0 the cable is labeled CPU0-CC-J3 to JCTR-J11.
–
In Core 1 the cable is labeled CPU1-CC-J3 to JCTR-J12.
•
Attach an A0314862 screw lock kit to the filter adapter in slot J29.
Plug an NT8D79AD cable into the adapter and secure it with the
screws on the cable:
–
In Core 0 the cable is labeled CPU0-CC-J1 to SEC PRI-J1.
–
In Core 1 the cable is labeled CPU1-CC-J1 to SEC PRI-J2.
Backplane
I/O slot
connector
J27
J26
8F
8D