Temperature Setting; Upkeep And Maintenance - Emos P5683 Manual

Temperature Setting

Set your temperature of choice by repeatedly pressing the up
Holding the arrow adjusts value faster.
Once temperature is set, wait several seconds until the value is automatically saved.
The display will then automatically show the current measured temperature.
To check your temperature setting, press the up or down arrow once.
Example: with temperature set to 50 °C, press the up or down arrow once. The display will show C 50.0.
Selecting Heating or Cooling Mode
Enter settings by long-pressing the down arrow
Use the arrows to choose between heating mode (C1 on the display) or cooling mode (C2 on the display).
Once the value of choice is set, wait several seconds until the value is automatically saved.
The display will then automatically show the current measured temperature.
Differences for cooling mode:
Switching in cooling mode is reversed: The thermostat activates the system if the measured tempe-
rature is higher than the set temperature.
Hysteresis
Hysteresis is the difference in temperature required for switching on and off.
If, for example, you set the temperature in heating mode to 42.5 °C and the hysteresis value to 2.5 °C,
the thermostat will activate your system as soon as room temperature drops to 40 °C and deactivate
it when temperature reaches 45 °C.
Enter settings by long-pressing the up arrow
Set your hysteresis value of choice by repeatedly pressing the up
Holding the arrow adjusts value faster.
Once the value of choice is set (e.g. 2.5 °C, displayed as d 2.5) wait a few seconds until the setting
is automatically saved.
The display will then automatically show the current measured temperature.

Upkeep and Maintenance

The product is designed to serve reliably for many years if used properly. Here are some tips for
proper operation:
• Read the manual carefully before using this product.
• Do not expose the product to direct sunlight, extreme cold and humidity and sudden changes in
temperature. This would reduce accuracy of detection.
• Do not place the product in locations prone to vibration and shocks – may cause damage.
• Do not subject the product to excessive force, impacts, dust, high temperatures or humidity –
doing so may cause malfunction, shorten battery life, damage batteries and deform plastic parts.
• Do not expose the product to rain or high humidity, dropping or splashing water.
• Do not place any open flame sources on the product such as a lit candle, etc.
• Do not place the product in places with inadequate air flow.
• Do not insert any objects into the product's vents.
• Do not tamper with the internal electrical circuits of the product – doing so may damage the
product and will automatically void the warranty. The product should only be repaired by a
qualified professional.
• To clean the product, use a slightly moistened soft cloth. Do not use solvents or cleaning agents
– they could scratch the plastic parts and cause corrosion of the electric circuits.
• Do not immerse the product in water or other liquids.
• In the event of damage or defect of the product, do not perform any repairs by yourself. Have it
repaired in the shop where you bought it.
• This device is not intended for use by persons (including children) whose physical, sensory or
mental disability or whose lack of experience or knowledge prevents them from using it safely.
/down
for approximately 3 seconds.
for approximately 3 seconds.
/down
4
arrow.
arrow.