Back-Fill And In-Fill The Stool - Siemens ST950/ Plus+ Installation Method Statement

Controller Cabinet
Method Statement
Apply silicone sealant Apply silicone sealant
between stool and case between stool and case
996/4/22026/100 996/4/22026/100

2.2 Back-fill and In-fill the Stool

On completion of the cable installation and testing the controller cabinet and stool can be back-filled
by using the appropriate material for the site layout. Once the back-fill is completed in-fill with kiln
dried sand, taking care that the compacted sand is at ground level when finished.
If any of the cables were replaced or moved during the installation of the controller cabinet then the
kiln dried sand in-filling must be made good before the sealing compound is introduced.
NOTE: The back-fill must be brought to a level such that once the decorative top surface is
completed the finish is at the surrounding ground level, particularly paying attention to any
hard standing around the controller base.
Controller Cabinet Stool Installation
Method Statement
Stool Installation
Figure 1 - Stool Installation with flagstone
Page 5 of 13
667/CC/53060/000
Issue 1
Unrestricted