Installation Of A Plus+ Sealed Cabinet Base - Siemens ST950/ Plus+ Installation Method Statement

Controller Cabinet
Method Statement

3.2 Installation of a Plus+ Sealed Cabinet Base

1. Remove the sealed base plate from the stool
2. Run a bead of silicone, 996/4/22026/100, all around the top rim of the stool ensuring no gaps
are left.
3. Fit the base plate in the orientation shown below. Note – Studs facing upwards, and sealed
blocks to the rear right hand side of the cabinet,
4. Run a bead of silicone all around the top rim of the stool ensuring no gaps are left.
5. Remove the stool door.
6. Fit the controller cabinet to the stool. Note – The door should be the same side as the stool
door
7. Using the Nuts and bolts supplied with the stool bolt the cabinet to the stool and tighten.
Ensure the silicone has sealed all around and wipe off any excess
Controller Cabinet Stool Installation
Method Statement
Stool Installation
Expansion for
street cables
Figure 7 – Plus+ Sealed Cabinet Base
Page 11 of 13
667/CC/53060/000
Figure 7.
Street Cables
Mains, BT
cables
Issue 1
Unrestricted