Siemens ST950/ Plus+ Installation Method Statement page 13

Controller Cabinet
Method Statement
Grease on studs
There should be some grease on each stud, please make sure it is there. If there is no grease then it is very
likely that the nut could cease making in unremovable in the future. If there is no grease then please apply
either carbon grease or copper grease to the stud.
3. Tighten down the nuts on the top clamp. Tighten each nut a little at a time so that the force
is distributed evenly across the plate. This will minimise any side loads from being applied to
the top clamp. Tighten until the bottom clamp touches the base plate.
4. Terminate the cables in the cabinet.
5. Replace the stool door.
Shim to suit
different cable
diameters.
Figure 8 – Plus+ Sealed Base Kit Components and Earthing Mechanism
Controller Cabinet Stool Installation
Method Statement
Stool Installation
Page 13 of 13
667/CC/53060/000
Issue 1
Unrestricted