SloanLED PosterBOX3 Installation Manual

PosterBOX 3
Installation Guide for 701946-6WLRP1, -6WSRP1
WARNING: Risk of electrical shock. New installation and LED Retrofit Kit installation requires knowledge of sign electrical systems. If not qualified, do
not attempt installation. Contact a qualified electrician. Follow all NEC and local codes. PosterBOX 3 is not suitable for submersion or direct exposure to
water for extended periods of time. AVERTISSEMENT: Risque de choc électrique. La nouvelle installation et l'installation du kit de modification à LED
nécessitent la connaissance des systèmes électriques de signalisation. Si non qualifié, ne tentez pas l'installation. Contactez un électricien qualifié.
Suivez tous les codes NEC et locaux. PosterBOX 3 ne convient pas à la submersion ni à l'exposition directe à l'eau pendant de longues périodes.

New Installation

Recommended tools:

• Measuring tape • Drill
• Wire strippers • Screwdriver

Layout Guidelines

It is recommended to test LED density in a sample cabinet to evaluate brightness, uniformity, and color.
If you have questions or require assistance in testing, please contact your SloanLED Customer Service Representative.
Y
X
1. Measure sign box to determine quantities of
PosterBOX 3 (see Power Supply capacity
table on page 3).
2b. If desired, double-stick tape can be used to mount
modules. Before mounting, clean mounting
surfaces inside of sign box with rubbing alcohol
and allow to dry for proper tape adhesion.
From factory
Built-in module spacer
For best performance
TIP: For best results, space modules adjacent to each
other using built-in module spacer. For best performance
in a single-sided box, mount modules on returns, near
rear wall of box (~.5 – .75" [1 – 2 cm]). For a double-sided
sign box, mount modules in center of returns.
3. Connections: Modules may be connected
in series or parallel. Modules should not be
looped to create a closed circuit. Cap all
unused, exposed wire ends.
For New Installation, proceed
with Step 1 below. For Retrofit
Installations, begin with
Retrofit Instructions on page 2.

Components list:

• SloanLED PosterBOX 3 modules,
model numbers 701946-(X)WLRP1 or
701946-(X)WSRP1
• SloanLED 24 V Class 2 output power supply
(refer to "24 VDC Power Supply Capacity
Chart" for appropriate model numbers)
• UL approved 18 AWG (1 mm²),
or larger diameter supply wire
• UL approved wire connectors appropriate
for wire gauge used
• Optional for mounting: Electrical grade
silicone, #8 (M4) sheet metal screws,
or 5/32" (4 mm) aluminum rivets
2a. Secure modules to sides of sign box using
#8 (M4) pan head sheet metal screws or
5/32" (4 mm) aluminum rivets.
Mounting Tabs
Secondary Wires
4. Mount Power Supply: Identify primary
wires, secondary wires, and location of
mounting tabs.
Primary Wires
PAGE 1 OF 3