SloanLED LEDStripe Installation Manual

LEDStripe
Installation Guide for 701189-C-(X)
1. Tools required: Cordless drill, drill bits,
#2 Phillips driver bits, wire stripper,
measuring tape, chalk line, marking pens,
miter saw (for custom cut lengths),
Multi-meter.
Chalk line
#8 pan head screw
4. Install mounting buttons: Snap a chalk line on
surface for mounting. Space mounting button 1.5"
(38 mm) from the end of each LEDStripe section and
every 24" (610 mm) on center throughout the length of
each LEDStripe section. For custom bends and tight
corners, see Step 9 for installation, and use a mounting
button every 12" (305 mm).
7. Corners: Corners should be installed with
one section slightly overlapping the other
leaving a minimum 0.25" (6 mm) space.
Optional corner covers can be snapped
into place.
2. Supplies required: Butt splices (22 - 18 AWG,
Red), field end cap kit, #8 Pan head, Phillips screws,
appropriate thread anchor for the surface it is
mounting to, transformer box, silicone sealant, conduit
and conduit connectors (water tight if mounting the
transformer in a box outdoors), disconnect switch, UL
Listed wet location, sunlight resistant PLTC cable.
Center bracket points up
5. Install LEDStripe sections onto buttons: Slide or Snap
LEDStripe sections onto mounting buttons with center
bracket facing up. NOTE: If installing in temperatures
below 40° F (4.5° C), leave a 0.25" (6 mm) gap between
8-ft (2.44 m) and 10-ft (3.05 m) pieces to allow for
expansion at warmer temperatures.
Small connector
0.5"
(6 mm)
gap
8. Connect pieces together: Make sure that tab is aligned
with locking clip. Once connected, hide wires at the back
of the LEDStripe in the mounting track. Use joint covers to
cover. CAUTION: To maintain the integrity of end caps and
prevent water penetration around wires, do not pull or tightly
bend wires or allow tension between wire connections.
ATTENTION: Pour maintenir l'intégrité des capuchons
d'extrémité et empêcher la pénétration d'eau autour des fils,
ne tirez pas ou ne pliez pas fermement les fils ou ne laissez
pas la tension entre les connexions des fils.
Large connector
3. Layout: Use an architectural drawing or
layout provided by SloanLED (sample
above) to determine the number and length
of LEDStripe sections and power supplies
required for your installation.
Secure section in place with #8 pan
head screws through bracket hole
6. Secure section in place: Use #8 pan head
screws to secure center bracket once all
sections are located on the mounting surface
Optional slide and mount rectangle
mounting buttons: (not included) are available
for hard to mount areas. Slide button onto the
back of the LEDStripe and use pan head screw
to secure to the wall.
LEDStripe Layout from SloanLED
PAGE 1 OF 4