SloanLED SignBOX 3 Installation Manual

SignBOX 3
Installation Guide for 701946-(X)WDLS1, 701946-(X)WSLS1, and 701946-(X)WSLT1
Tools required: Measuring tape, wire strippers,
gloves, cutting tool (sheet metal shears/snips,
scissors, utility knife), drill, and screwdriver.

Single and Double-sided Installations Using Part numbers 701946-(X)WDLS1 or 701946-(X)WSLS1

New Installation
1. Cut straps and wires
between modules to obtain required length.
Tip: Before cutting wires, refer to Joining
Product section.
Layout: To populate sign, refer to
SignBOX 3 Module density guidelines,
test, or contact your SloanLED Representative
for recommendations.
Cabinet Face
Frame Support
(Tension Bar) SignBOX 3 modules
• SignBOX 3 assemblies:
• Double-sided assemblies: SloanLED
model numbers 701946-(X)WDLS1
• Single-sided assemblies: SloanLED
model numbers 701972-(X)WSLS1
• Single-sided module: SloanLED
model numbers 701972-(X)WSLT1
• SloanLED 24 V Class 2 output power supply
(refer to "24 VDC Power Supply Capacity
Chart" for appropriate model numbers)
• UL approved 18 AWG (1 mm²),
or larger diameter supply wire
• UL approved wire connectors appropriate
for wire gauge used
• SignBOX 3 mounting hardware
(for 701946-(X)WDLS1 and
701946-(X)WSLS1 Assemblies):
Clips (P/N 402106), Brackets (P/N 402107)
(optional), and Couplers (P/N 402108)
(as needed).
• #8 (M4) self-drilling/self-tapping tek screws
(required to pierce through strap),
minimum length 5/8" (16 mm)
• Optional: Electrical grade silicone,
nylon zip ties, double stick mounting tape
To minimize potential for shadows in
applications when using frame support tubes,
mount modules or frame support tubes such that
tubes are centered in between modules and at
a depth that will not directly interfere with beam
angle of LEDs. Use SignComp Adjustable Frame
Brace (P/N 5357) or equivalent.
PAGE 1 OF 5