SloanLED PosterBOX Installation Manual

PosterBOX
Installation Guide for 701946-CWPBM and 701946-NWPBM
WARNING: Risk of electrical shock. New installation and LED Retrofit Kit installation requires knowledge of sign electrical
systems. If not qualified, do not attempt installation. Contact a qualified electrician. Follow all NEC and local codes. PosterBOX
is not suitable for submersion or direct exposure to water for extended periods of time. AVERTISSEMENT: Risque de choc
électrique. La nouvelle installation et l'installation du kit de modification à LED nécessitent la connaissance des systèmes
électriques de signalisation. Si non qualifié, ne tentez pas l'installation. Contactez un électricien qualifié. Suivez tous les codes
NEC et locaux. PosterBOX ne convient pas à la submersion ni à l'exposition directe à l'eau pendant de longues périodes.
New Installation
Tools required: Measuring tape, wire
strippers. Optional: Drill, screwdriver.
Y
X
1. Measure sign box to determine quantities of
PosterBOX (see Power Supply capacity
table on page 3).
4. Fasteners: If desired, modules can be secured
using #8 (M4) pan head sheet metal screws or
5/32" (4 mm) aluminum rivets.
2. Clean sign box: Using a non-oil based cleaner,
clean the inside surface of the sign. Be sure to
clean any mounting surfaces with alcohol for
proper tape adhesion.
5. Connect modules: Each module has
2 ft (0.6 m) of wiring on each side. Cut
wires as needed leaving enough to connect
the modules. Modules may be connected in
series or parallel.
For New Installation, proceed with Step
1 below. For Retrofit Installations, begin
with Retrofit Instructions on page 2.
Components list:
• SloanLED PosterBOX modules, model numbers
701946-CWPBM and 701946-NWPBM
• SloanLED 12 V Class 2 output power supply
(refer to "12 VDC Power Supply Capacity
Chart" for appropriate model numbers)
• UL approved 18 AWG or larger diameter
supply wire
• UL approved wire connectors appropriate
for wire gauge used
• Optional for mounting: Electrical grade silicone,
#8 (M4) sheet metal screws, or 5/32" (4 mm)
aluminum rivets
3. Peel and stick: Using provided double stick
tape, mount PosterBOX modules to sides of
sign box. For best performance it is
recommended that the modules be mounted
flush against the rear wall of the sign box.
6. Units may be mounted in any orientation
using mounting tabs.
PAGE 1 OF 3