Table of Contents
Advertisement
Using the ScheduleCalc
Important Note!
Unless otherwise indicated, all sample prob-
lems in this section assume the ScheduleCalc
is in its default state. If not, use [Conv] [x]
to reset the calculator.
Time Values
If the "
" preference setting is "
",
SECS
ON
the display shows a place holder (00)
for seconds even if the [Sec] key was
not used.
If set to "
", you must press the [Sec]
OFF
key to display the seconds placeholder.
If entering points in time, it is not nec-
essary to use the [:] key. See Method 5
for an alternate method.
When entering time values, you may use
any of the following entry methods.
However, remember to always enter
hours first, then minutes, then seconds.
Note: In the following examples, the first
value shown is with the "
" setting
SECS
"
." The second value is with the "
"
OFF
SECS
setting "
."
ON
18—ScheduleCalc™
Advertisement
Table of Contents
