Calculated Industries 4030 User Manual page 99

(Cont'd)
Preference
3) Volume Display Format
(n/a for Metric Mode)
4) Rake Wall Descending or
Ascending
5) Jack Rafters Descending or
Ascending (n/a for LT model)
6) Jack Rafters O-C or Mate
(n/a for LT model)
7) Fraction Standard or Con-
stant
Options
*
Standard (if units entered are the same—
e.g., ft x ft x ft—the answer will remain in this format
(cu. ft), but if units entered are different—e.g., feet x
feet x inches—vol. answer will always be displayed in
cubic yards)
Cubic Yards (vol. answers always displayed in cu.
yards, regardless of unit entry—e.g., feet x feet x feet
= cu. yds)
Cubic Feet (vol. answers always displayed in cu.
feet, regardless of unit entry—e.g., inches x inches x
inches = cu. ft)
Cubic Meters (vol. answers always displayed in cu.
meters, regardless of unit entry—e.g., feet x feet x
feet = cu. meters)
*
Descending (Rake Wall studs are displayed from
largest to smallest size)
Ascending (Rake Wall studs are displayed from
smallest to largest size)
*
Descending (Jack rafters are displayed from largest
to smallest size)
Ascending (Jack rafters are displayed from smallest
to largest size)
*
OC-OC (on-center spacing maintained on both regular
and irregular sides)
JAC-JAC (regular/irregular Jack rafters "mate" at the
hip/valley, i.e., on-center spacing not maintained on both
sides)
*
Standard (standard fractional resolution)
Constant (fractions are always based on user-set frac-
tional resolution; default 16ths)
(Cont'd)
User's Guide — 97