Calculated Industries 4030 User Manual page 120

(Cont'd)
New/Enhanced Function
Preference Settings
Rake Wall
Rafter Cutting Angles
Stairs
Weights
118 — CONSTRUCTION MASTER PRO
Description
Dimensional formats for calculated areas and vol-
umes may be set to display in preferred formats
(e.g., sq. feet, cu. yards). Also, Jack rafters and
Rake Wall stud sizes may be set to display in either
ascending or descending order.
tings on page 96.)
Rake Wall is a second function of the [Rise] key.
The value stored in the on-center register –
[Stor] [7] – is used for the on-center spacing for
Rake- Wall studs.
You may now input a base height from which all
Rake Wall studs will be calculated – e.g.,
[5] [Feet] [Conv] [Rise] will calculate Rake Wall
studs from a base of 5 feet rather than zero.
Based on your Preference setting, Rake Walls can
be calculated in descending (default) or ascending
order.
You may now calculate Rafter Cutting Angles: Di-
agonal Plumb, Level and Hip/Valley/Jack Plumb,
Level, Cheek.
Desired value for Riser Height is stored via
[Stor] [Stair]. (Default value is 7-1/2 inches.)
You may now store a desired Tread Width value via
[Stor] [M]. (Default is 10 inches.) This allows you to
enter only a floor-to-floor rise or only a total run and
still calculate an entire stairway.
Weight per volume is now permanently stored using
[Stor] [8].
Units available in Pounds (lbs.), Tons, Kilograms
(kg) and Metric Tons.
(See Preference Set-