Safety Instructions For Commissioning - Siemens Simotics T-1FW6 Operating Instructions Manual

Commissioning

6.1 Safety instructions for commissioning

6.1 Safety instructions for commissioning
Risk of death and crushing as a result of permanent magnet fields
Severe injury and material damage can result if you do not take into consideration the
safety instructions relating to permanent magnet fields.
•
injury and material damage if EMC safety requirements are not observed
Risk of death, serious personal injury, and/or material damage can occur if a machine that
does not fulfill the recognized EMC safety requirements is commissioned.
•
•
Danger of severe injuries caused by unexpected movements of the motor
Unexpected movements of the motor may cause death, serious injury (crushing) and/or
property damage.
•
•
•
•
•
•
•
84
WARNING
Refer to Chapter "Danger from strong magnetic fields (Page 26)".
WARNING
Plants and machines with converter-fed low-voltage three-phase motors must fulfill the
protection requirements of EMC Guideline 2014/30/EU.
The plant engineer is responsible for ensuring that installation is carried out in an EMC-
compliant manner. Use shielded signal and power cables. Apply the EMC installation
guideline of the converter manufacturer. For Siemens converters, this is available under
document order No. 6FC5297-□AD30-0□P□.
WARNING
Never work in the vicinity of rotating parts for a switched-on machine.
Keep persons away from rotating parts and areas where there is a danger of crushing.
Ensure that the axis transversing angle is free of any obstruction.
Check before switching on the commutation! Also observe the instructions of the drive
system being used.
Set the motor current limiting too low values.
Set the speed limitation to small values.
Monitor the end positions of the motor.
1FW6 external rotor built-in torque motors
Operating Instructions, 12/2020, A5E49196960B AB