Table of Contents
Advertisement
Simcenter Qsources Low Frequency Monopole Source 2v9C.docx
Safety instructions
Please follow the instructions below in order to produce correct results and prevent unnecessary damage. It will
also allow the user to maintain right to warranty. Please find a one-page summary comprising of all essential
operating do's and don'ts at the end of this manual, designed to be printed out and kept close to the product.
· Never connect the power leads to a DC power source or to a 115 V or 230 V mains outlet. This will destroy the
source and its cabling. Connection to a 115 V or 230 V mains outlet also poses a severe risk for electric shock,
burns and fire.
· It is advised to limit the signals going into the device within the frequency range from 10 ‒ 3 000 Hz.
· The reference sensor should be used in voltage AC mode, not IEPE.
· Never connect the source to a power amplifier without the protection circuit.
· Do not:
Drop the source on a hard surface.
o
Open the housing.
o
Submerge the volume source in water or other fluid.
o
Use the source in an environment warmer than 40°C or colder than 0°C.
o
Transport the source in an environment warmer than 70°C or colder than -10°C.
o
Short the power cable once they are connected to a power amplifier.
o
Damage as a result of not following the above instructions will result in a loss of the right to warranty.
7
Advertisement
Table of Contents
