Copeland Furniture Invigo Instructions

Notice: Drawings will not match every Invigo
configuration

Tools required

First Time Operation

If using a power strip (not included),
place it in the wire management tray.
Invigo desks include a generous wire
management tray (Figure 1.) for routing the
cords for all desktop accessories, powered
inserts or other electrical devices. Users
may wish to consolidate all cords into a
power strip or surge protector (not included)
so that a single cord runs from the desktop
to the wall socket.
Level the desk with the floor surface by
turning one or more of the four leg-levelers
underneath the desk feet (Figure 2).
Attach plug end of desk power cable or
power strip with desk power cord attached
to standard 110V/60Hz wall socket. Ensure
there is enough play in the cable to allow
the table to raise and lower.
Desk foot
I n s t r u c t i o n s f o r
Privacy panel
none
Leg leveler
Desk top
Power strip
Desk feet
Ensure that there are no obstacles either
above or below the motion path of the
desk and the power cable and that the
desk is not touching any walls or other
obstacles.
I n v i g o D e s k s
Pencil tray
Desk feet
Wire Management
tray
Figure 1.
Place power strip in
wire management tray
Figure 2. Level leg-levelers
1