Intelligent Auto Install Requirements; Running The Intelligent Auto Install Program - 3Com EtherLink 3C905C-TX User Manual

40 C
HAPTER

Intelligent Auto Install Requirements

To use the Intelligent Auto Install program:
If you have more than one 3C905C NIC installed, follow
the NetWare installation instructions in the 3Com NIC
Configuration and Diagnostic program for DOS. (See
the DOSDIAG.TXT file located in the HELP directory on
EtherDisk diskette 3 for instructions on using this program.)

Running the Intelligent Auto Install Program

To run the Intelligent Auto Install software to install the
client software and drivers for a NetWare network:
1 Install the NIC and connect it to the network, as
described in Chapter 2.
2 Reboot to DOS.
3 Insert EtherDisk diskette 3 in drive A.
4 At the DOS prompt, enter:
a:install
The EtherDisk diskette main menu appears.
5 Select Auto Install and Config for NetWare and
press Enter.
6 Select DOS, Windows 3.1x, or Windows for
Workgroups 3.11, and follow the instructions.
7 When the installation process is finished, remove
EtherDisk diskette 3 and reboot the PC.
If you are running Windows 3.1x, after you connect to
the NetWare server, run the WSINSTALL program for full
Windows support. Contact your system administrator for
the location of this NetWare utility.
4: N W C
ET ARE LIENT AND
Make sure that your PC has only one 3C905C
NIC installed.
Make sure that you are using NetWare 3.x or 4.x as
your network operating system.
Make sure that your PC has at least 1 MB of available
hard drive space.
S D I
ERVER RIVER NSTALLATION