Tripp Lite SMART1524ET Owner's Manual page 43

Operation
Program Input Contact - Selecting the PROGRAM I/P CONTACT option enables
configuration of one user-supplied UPS input CONTACT-CLOSURE sensor. Navigate
to select the closest naming option for the reported condition from the sub-menu
list. Once configured, shorting the input sensor contacts will report the external
condition by the selected name (contact closure sensor naming options are shown
below). Select "User program" if your sensor type is not listed. Default setting is
EXT FAN FAILED.
[0-MAIN MENU]
[6-PROGRAMMABLE CONTACTS SETUP]
[76-PROGRAM I/P CONTACT]
Current Setting is [EXT FAN FAILED]
0) Set to [USER PROGRAM IN]
1) Set to [EXT ALARM]
2) Set to [EXT BATT ALARM]
3) Set to [EXT FAN FAILED]
4) Set to [DOOR UNLOCK]
>
7. Event Log - This option enables viewing and resetting event log entries.
[0-MAIN MENU]
[7-EVENT LOG VIEW]
77)Display Event Records
78)Reset Event Log
>
Event Log Sub-Menu Options
Display Event Records - Selecting this option enables viewing of up to 200
logged events. To view events, select the DISPLAY EVENT RECORDS option and
pick from the four available ranges of numbered events. Once a range of events is
selected, they will be available for viewing in a continuous list, each referenced by
the corresponding Event Number, Date, Time and Event Type. Up to 200 records
are stored. The oldest values will be automatically cleared once the maximum
number of records is reached.
[0-MAIN MENU]
[7-EVENT LOG VIEW]
77)Display Event Records
0) Event #001-#050
1) Event #051-#100
2) Event #101-#150
3) Event #151-#200
>
43