Machine Cleaning - Numatic CRG 8055/100T Owner's Instructions Manual

Machine Cleaning

!
After use, empty waste water tank using emptying hose and flush-out with
A
clean water.
Remove floor tool vacuum hose ensuring you remove the U-bend clip and flush
B
out with clean water.
Empty clean water tank, using emptying hose and again flush out with clean
C
water.
Remove hose.
Note: The separator can be hung from either side of the top tank while you maintain the machine using the clip on
the front of the lid.
When refitting the separator make sure you engage the front of the separator BEFORE pushing the separator down.
Refit the vacuum hose.
www.numatic.co.uk
12
Always ensure that the machine is switched off prior to any maintenance.
Remove separator and clean.
A
C
Clean and examine rubber seal during
each clean.
!
B