Machine In Use; Off-Aisle Cleaning Kit - Numatic CRG 8055/100T Owner's Instructions Manual

!

Machine in Use

To operate, select forward and depress the accelerator pedal.
Note: The machine will not operate in reverse with the floor tool lowered.
Vacuum pick-up and water flow will turn on if selected, and providing the brush and floor tool are
in the lowered position, the machine will move forward.
Clean water is dispersed evenly via 'THRU- FEED' scrubbing brushes.
The waste water is then retrieved by the suction floor tool.
Overlap each scrubbing path by 10cm to ensure an even clean.
After stopping, let the vacuum motor run for 10 seconds to collect any water left in the vacuum
hose, then switch the vacuum motor off.
On heavily soiled floors use a 'double scrub' technique.
First pre-scrub the floor with the floor tool in the raised position, allow the chemicals time
to work, then scrub the area a second time with the floor tool lowered.
If your machine leaves streaks on the cleaned floor, either clean the floor tool blade or
adjust blade height for optimum performance.
Brush deck in lowered position.
Off-aisle Cleaning Kit (Optional Extra Accessory) 606182
The optional off-aisle cleaning kit gives added flexibility to the operator.
The kit can be used to clean hard to reach / inaccessible areas.
Remove the vacuum hose from the floor tool and attach to the off-aisle kit.
To operate the vacuum, press the vacuum switch on.
Vacuum switch.
Do not operate the machine on inclines that exceed 11%.
Floor tool lever in lowered position.
Note: Return the hose to the floor tool once
finished using the off-aisle facility.
Machine Operation
Set lever to forward.
Low
Water flow rate selection.
Adjusting the blade height.
T 01460 68600
!
High
11