Hose U Bend Clip; Fitting The Floor Tool; Breakaway Floor Tool Feature - Numatic CRG 8055/100T Owner's Instructions Manual

Machine Set-up Guide
Hose U-bend Clip
The U-bend in the hose prevents water spillage when the vacuum is switched off.
Refit vacuum hose to the floor tool when finished.
Note: DO NOT push the vacuum hose
onto the floor tool with the floor tool
in the raised position.

Fitting the Floor Tool

Note: Raise floor tool before driving to the cleaning area.
The machine will not operate in reverse with the floor tool lowered.
Break-away Floor Tool
The floor tool design incorporates a safety knock-off feature, this allows it to safely
disengage from its mounting should it become caught on an obstruction during
forward movement.
Make sure you do not over tighten the retaining knobs.
Slide floor tool onto bracket.
www.numatic.co.uk
6
Tighten retaining knobs to finger tight and
attach hose.
Lower the floor tool.
Raise the floor tool.