Brother HL-5030 User Manual page 48

Envelopes that have been creased after they have been printed:
At the back of the printer, open the back output tray and push down the blue tabs at the left and right
hand sides (as shown in the figure below). When you have finished printing your envelopes, close
the back output tray to reset the two blue tabs back to their original position.
Figure 1-37
5
Put envolopes in the MP tray so that they touch the back of the tray and remain under the maximum
paper height guides on both sides of the tray. Do not put more than 3 envelopes in the MP tray at
any one time, or it may cause a jam.
Figure 1-38
Make sure that the envelopes are neatly stacked and in the proper position in the MP tray. If they
are not, the envelopes may not be fed properly, resulting in a skewed printout or a jam.
ABOUT THIS PRINTER 1 - 31