Brother HL-5030 User Manual page 49

6
Press and slide the paper-width guide to fit the envelope size.
DL size double-flap envelopes
If the DL size double flap envelope is creased after printing, go to the Basic tab, select Paper
Size and then select DL Long Edge. Put a new DL size double-flap envelope in the MP tray with
the longest edge of the envelope in first, then print again.
When you put envelopes in the MP tray, please remember the following;
During printing, the inside tray rises to feed envelopes into the printer.
The side to be printed on must be face up.
Put the leading edge (top of the paper) in first and push it gently into the tray.
The top of the envelope stack must be under the maximum paper height guides that are on both
sides of the tray.
7
Send the print data to the printer.
8
After you finish the print job, close the back output tray.
If envelopes get smudged during printing, in the printer driver select MP Tray as the Paper
Source for a straight paper path. Then, set the Media Type to Thick Paper or Thicker Paper
to increase the fixing temperature. To adjust the print density setting, see Chapter 3.
Envelope joints that are sealed by the manufacturer should be secure.
All sides should be properly folded without any wrinkles or creases.
1 - 32 ABOUT THIS PRINTER
Figure 1-39