Connections - Gemini 814FWH Installation And Use Manual

Kit parking sensor
Table of Contents

Advertisement

Clean thoroughly the plastic brackets (7 or 8) and around the holes, apply "PRIMER"
!
(14), let dry for at least one minute and then proceed as follows.
+18°C
14
8
7
9
protective film from the adhesive and apply it to the bracket
or snap bracket
10
7
8
1
BROWN
PAGE 08 - INSTALLER MANUAL
Use the supplied tie
(13) or bolts (3) to
secure the control units
to the front bumper.
Snap the sensor in the bracket
(7 or 8), peel off the
(10) i
n hole from outer part of bumper and
then insert sensor
.
In both cases position the plastic brackets so that the
connector of the sensor comes out horizontally
NO
YES
11
1
1
1
1
Check the wireless communication and the length of the cables before proceeding with
!
!
Install the control unit (4) in the front bumper away from heat sources.
!
Connect the sensors (1) and route the power supply cable inside the engine compartment or the
vehicle cabin.
!
Fix the display (2)
inside the vehicle cabin, in a dry place, away from eventual water infiltrations and
heat sources where it can easily be seen during the parking and reversing manoeuvers
!
Connect the BLACK-BLUE wire of the control unit (4) to positive or to positive under key.
.
If the power supply wire of the control unit is connected to a permanent positive, before
!
you start making the connection, read the instructions for pairing the control units with
!
Connect the BROWN wire of the front control unit (4) to the metal frame of the vehicle (ground).
!
(Optional) connect the BLACK-YELLOW wire of the control unit (4) or of the display (2) to the
o
dometer signal
of the vehicle (
and to adjust the pulses
!
Connect the BLACK-BLUE wire of the display (2) to the positive under key of the vehicle.
!
Connect the BROWN wire of the display (2) to the metal frame of the vehicle (ground).
!
Insert the 3-way connector in the display.

8.0 - CONNECTIONS

+12V
the final positioning of the accessories.
the display.
see "setting of parameter" to program the control unit or the display
).
.
INSTALLER MANUAL - PAGE 09

Advertisement

Table of Contents
loading

Table of Contents