Download
Share
Print this page
Gemini 812F Installation And Use Manual
  1. Manuals
  2. Brands
  3. Gemini Manuals
  4. Automobile Electronics
  5. 812F
  6. Installation and use manual
Gemini 812F Installation And Use Manual

Gemini 812F Installation And Use Manual

Kit parking sensor
Hide thumbs

Advertisement

Quick Links

Download this manual
INSTALLATION CERTIFICATE
The undersigned qualified installer attests to have personally fitted the here described system following the
manufacturer instructions.
By :
Sold on :
.................................................................
Car :
..........................................................................................................................
GEMINI Technologies S.p.A.
Via Luigi Galvani 12 - 21020 Bodio Lomnago (VA) - Italia
Tel. +39 0332 943211 - Fax +39 0332 948080
Web site: www.gemini-alarm.com
Type of product :
812F
Reg. n.532-A
UNI EN ISO 9001:2008
KIT Parking
Sensor 812F
INSTALLATION AND
USE MANUAL
UK
AC 2752/UK Rev. 02 - 11/11

Advertisement

loading

Related Manuals for Gemini 812F

Summary of Contents for Gemini 812F

  • Page 1 INSTALLATION CERTIFICATE The undersigned qualified installer attests to have personally fitted the here described system following the manufacturer instructions. By : KIT Parking Sensor 812F Type of product : Sold on : 812F ..............INSTALLATION AND USE MANUAL Car : ..........................
  • Page 2 Sensor 1: front with shortest cable. Sensor 4: front with longest cable. GREEN BLACK-BLUE +12/24V BLACK-YELLOW km/h MUTE GREY-RED MAIN UNIT GREEN TECHNICAL SPECIFICATIONS Supply voltage From 9 to 30 Vdc OPTIONAL Current consumption when ignition is ON 200mA max. Service temperature range 10 x From -30°C to +70°C...

  • Page 3: Table Of Contents

    The sensors will reactivate when the vehicle slows down again to the preselected speed (see The warranty is valid exclusively at authorized Gemini Technologies centers. “Parameters”, parameter 11). The manufacturer declines any responsability for eventual malfunctions of the parking sensors or any Long-pressed (about 5 sec., you will hear a beep): to desactivate the sensors until you turn the...

  • Page 4: Troubleshooting Guide

    INSTALLER MANUAL 3.3 - TIME-ACTIVATED SENSORS ( odometer not connected) 5.0 - INSTALLATION OF SENSORS Check setting of function 12 (delay in deactivation of front sensors , “setting of parameters”). To install the sensors on a metal bumper, you must use appropriate adapters ( supplied) The front sensors can be activated by turning the ignition ON or by pressing the push-button with the LED.

  • Page 5: Connections

    6.0 - CONNECTIONS Clean thoroughly the plastic brackets (6 or 6a) and around the holes, apply “PRIMER” (12), let dry for at least one minute and then proceed as follows. 6 6a MUTE +12V Check the length of the cables before proceeding with the final positioning of the Remove the protective film from the adhesive (7) and apply it to the bracket (6 or 6a) or snap the accessories.

  • Page 6: Programming

    7.0 - PROGRAMMING 8.0 - SETTING OF PARAMETERS PARAMETERS RANGE SETTING Only expert users should modify these settings to avoid malfunctions of the parking system. Volume of buzzer 0, 1, 2 ( Ref.1 Detection range of front corner sensors From 50 to 95 cm The display will indicate: STOP zone of front corner sensors From 25 to 50 cm...