Table of Contents
Advertisement
9.0 - PAIRING OF CONTROL UNIT WITH DISPLAY
When pairing, make sure no similar control units are activated in the
!
Once the front control unit is powered, you will have one minute to pair it to the display.
!
If one minute has lapsed, you will have to restart the pairing procedure (disconnect and
reconnect the front control unit).
!
Supply the display only.
!
Supply the front control unit.
!
P
ress and keep pressed for about two seconds the two push-buttons on the display
If the display shows "E1" it means that there are other activated control units in the
!
surroundings; move the vehicle or turn off the other control units.
!
When the letters "LE" and the upward arrow icon light up on the display, the front control unit has
been paired
.
!
The pairing procedure is completed; parameters can eventually be modifed according to individual
needs
.
10.0 -
LEARNING OF ODOMETER PULSES
(optional, only with display wire
This procedure is useful when you do not know the odometer pulses of the vehicle and
!
the display cable must be connected to the odometer.
Use this procedure only if the customer wants the overspeed alert feature.
!
Turn the ignition "ON".
!
Enter in the programming mode (see chap.12.0), select parameter 14 and set it to "3"
!
Turn the ignition "OFF".
!
Turn the ignition "ON";
the speed displayed will be 50Km/h.
!
Increase the vehicle speed until the vehicle reaches the speed indicated on the display, then press
the left-hand push-button
.
!
If both speeds are identical, press the right-hand side push-button
!
The display will turn off until the vehicle reaches
!
The system has automatically registered the vehicle odometer pulses per meter
!
Viceversa, if
the reading is incorrect or the odometer signal is lost, the display will show "E3", which
means the operation was not successful.
Turn the vehicle "OFF" and "ON" again and repeat the entire procedure
PAGE 10 - INSTALLER MANUAL
surroundings.
.
)
.
.
15Km/h.
.
.
11.0 - TESTING
!
Turn the ignition key "ON".
!
P
ress and keep pressed one of the two push-buttons on the display
programming mode; select parameter
"14".
!
P
ess and keep pressed one of the two push-buttons on the display (2) until the system enters in the
parameter settings
.
!
Select value "1" and turn ignition key "
OFF".
!
Turn ignition key "ON"; the vehicle and antenna (without the reception symbols) icons will light up
on the display
.
!
Supply the control unit; the display will show the icons of the vehicle, the arrow indicating the
activated control unit (front) and the antenna with the reception symbol
!
If necessary test the sensors; depending on the detection zone, the display will show the relative
icons of the zones and the distance from the obstacle
!
Once testing is completed, restore setting of parameter
(2)
until the system enters the
.
.
"14".
INSTALLER MANUAL - PAGE 11
Advertisement
Table of Contents
