Table of Contents
Advertisement
7.0 - CONNECTIONS
Check the wireless communication and the length of the cables before proceeding with
!
the final positioning of the accessories.
!
Install the control unit (4) in the rear bumper away from heat sources.
!
Connect the sensors (1 e 2) and route the power supply cable inside the vehicle luggage
compartment.
!
Connect the BLACK-BLUE wire of the control unit (4) to the positive of the reverse light.
!
Connect the BROWN wire of the control unit (4) to the metal frame of the vehicle (ground).
!
Fix the display (3)
inside the vehicle cabin, in a dry place, away from eventual water infiltrations and
heat sources where it can easily be seen during the parking and reversing manoeuvers
!
Connect the BLACK-BLUE wire of the display (3) to the positive under key of the vehicle.
!
onnect the BROWN wire of the display (3) to the metal frame of the vehicle (ground).
!
(Optional) connect the BLACK-YELLOW wire of the display (3) to the o
(
see chap.
10.0 and 11.0
for programming and setting instructions This connection must be done if
the customer wants to set the overspeed audible alert, see
!
Insert the 3-way connector in the display.
PAGE 08 - INSTALLER MANUAL
2
1
1
2
R
.
dometer signal
of the vehicle
.
chapter 5.0).
8.0 - PAIRING OF CONTROL UNIT WITH DISPLAY
When pairing, make sure reverse gear is disengaged
!
activated in the surroundings
!
Supply the display (turn vehicle ignition key to "ON).
!
P
ress and keep pressed for about two seconds the two push-buttons on the display
!
The letters "LE" will light up on the display
If the display shows "E1" it means that there are other activated control units in the
!
surroundings; move the vehicle or turn off the other control units.
!
Supply the rear control unit (e
ngage reverse gear and wait until the downward arrow icon lights up;
this will indicate the rear control unit has been paired
!
The pairing procedure is completed; parameters can eventually be modifed according to individual
needs
.
9.0 -
LEARNING OF ODOMETER PULSES
This procedure is useful when you do not know the odometer pulses of the vehicle and
!
the display cable must be connected to the odometer.
This procedure must be used if the customer wants the overspeed alert feature
!
Turn the ignition "ON" and engage the reverse gear.
!
Enter in the programming mode (see chap.
pressing one of the two push-buttons on the display for about 3 seconds
!
Turn ignition key
"OFF".
!
Turn the ignition "ON";
the speed displayed will be 50 km/h
!
Increase the vehicle speed until the vehicle reaches the speed indicated on the display, then press
the left-hand push-button f both speeds are identical, press the right-hand push-button
; i
!
The display will turn off until the vehicle reaches
!
The system has now automatically registered the odometer pulses per meter
!
Viceversa, if
the reading is incorrect or the odometer signal is lost, the display will show "E3", which
means the operation was not successful
entire procedure
.
and
no similar control units are
.
.
)
.
(o
ptional
)
10.0),
select parameter 14 elect value 3 and set it by
, s
).
.
15 km/h.
.
. T
urn the vehicle "OFF" and "ON" again and repeat the
INSTALLER MANUAL - PAGE 09
.
.
Advertisement
Table of Contents
