Table of Contents
Advertisement
The PDC kit is connected as follows:
1.
Connect the YELLOW wire to ignition.
2.
Connect the BLACK wire to the vehicle chassis (ground).
3.
Connect the buzzer connector (BLACK/BLACK) wire to the corresponding counterpart on the control unit (see wiring diagram).
4.
Connect the 4 black-sheathed wires coming out of the control unit to the 4 sensors (the longest wires to the sensors at the opposite end of the control unit).
5.
After the ON/OFF switch is fitted on the dash, plug the terminals in the 24-pin connector as follows: RED => pin.11, BLACK => pin 10 and WHITE => pin 3.
9.1 - OPTIONAL CONNECTIONS:
1.
VIOLET wire: by connecting this wire to the odometer you can set a speed threshold so that the system automatically shuts OFF when the vehicle exceeds the set speed
and automatically turns ON when the speed falls below the set speed (parameter "58").
The system can also be set to turn ON when ignition is switched ON and turn OFF when the vehicle reaches the set speed (parameter "59"). In this case the system can
only be reactivated via the manual switch.
2.
PINK/BLACK wire: by connecting this wire to the radio MUTE, the audio volume will be slightly lowered when the system is active.
9.2 - CHECK AFTER INSTALLATION
1.
Reconnect the negative battery terminal.
2.
Turn ignition key ON. Activation will be confirmed by a short Beep and the LED on the manual switch will turn ON.
3.
Test the sensors one by one for detection by moving different obstacle simulators in front of the vehicle. The system should beep according to the warning zones.
Distances and detections are approximate because of the position, size and shape of the objects. For a more accurate detection, test the sensors by placing
the objects at different angles of the sensors field of view.
If needed, the sensor sensitivity can be modified (see par.11.0).
4.
If the parking sensors are working correctly, secure the bumper in place.
9.0 - ELECTRICAL CONNECTIONS
Designed and manufactured by GEMINI TECHNOLOGIES srl ‐ Via L. Galvani, 12 – 21020 Bodio Lomnago (VA) – Italy
Tel. +39 0332 943211 – Fax +39 0332 948080 – www.gemini‐alarm.com
ISO 9001 CERTIFIED COMPANY
Rev.00 09/2022
5/9
Advertisement
Table of Contents
